Header bars sit above door and window openings. Each one picks a profile and the openings it applies to — by span width, wall position, and opening type.
Header Bars is one of the Client Tools in SalesView, found in the left menu under Catalog Editor.
Not available on shed sites.
What you can change
Which header bar profiles are available
The label customers see
The opening width range a bar applies to
Which walls it appears on
Common tasks
Add a header bar
Select + Add header bar.
Pick a shape under Header bar type. Profiles already on your site are marked in use.
Enter the Label customers see.
Under Header width, leave Use the default range on, or switch it off to set your own minimum and maximum.
Under Wall position, choose Sidewall, Gable End, or Both.
Select Add header bar.
Change the openings a header bar applies to
Select Edit on the bar.
Adjust Header width and Wall position, or use the Visibility tab to limit it by opening type.
Save.
Stop offering a header bar
Select Edit on the bar and switch Enabled off.
Good to know
If a bar's width range overlaps one you already have, the tool warns you before you save. Two bars covering the same width produce unpredictable results, so narrow one of the ranges rather than leaving both.
Bars that are switched off are hidden until you tick Show disabled.
Publishing your changes
Your changes aren't live until you publish them. See Getting Started with Client Tools for how publishing works.